Do-it INT-4-AB In-Line Trolling Sinker Mold

Need to get a crawler harness into the strike zone, or run a crankbait or spoon deeper? With the Do-it In-line Trolling Sinker Mold, you can easily make the weights needed to get the job done, and at a fraction of the usual cost. Hydrodynamic design slips easily through the water with minimal resistance, allowing your bait to run unimpeded. Molds 4 sizes at once; use No. 1 brass eyes.

Do-It In-Line Trolling Sinker Molds - Barlow's Tackle

Trolling Sinker Mold

Jig & Sinker Mold Catalogue: Visit For Your Copy of, PDF, Fish And Humans

3141 New Do-It In Line Trolling Sinker Mold INT-12B 12 oz Inc 100 #3 Wire Eyes

Do-it In-line Trolling Sinker Mold

3138 New Do-It In Line Trolling Sinker Mold w/#1 Brass Wire Eyes - 1/2-1 1/2 oz

DO IT SINKER MOLDS

Do-It Mold Trolling Sinker - Sz: 1/4, 3/8, 1/2, 5/8, 3/4

DO IT SINKER MOLDS

Inline Trolling Sinker Molds

Do-it In-line Trolling Sinker Mold

Do-it Molds - In-Line Trolling Sinker Mold - 2oz 3oz 4oz – James' Tackle

NOMAD RIPTIDE SLOW SINK LURE 155mm

Inline Trolling Sinkers

Required Insert #1 brass wire eye not included on this order Do it Mold (3138) INT-4-AB

Do It Mold in-Line Trolling Sinker Sz: 1/2, 3/4, 1, 1 1/2 Oz