Rod Holder - Vertical Side Mount - T-H Marine Supplies

$ 23.50 · 4.9 (135) · In stock

Universal mounting rod holder Fits on round or square rails Flush mounts on horizontal surfaces Adjustable 360 degrees Installs in almost any application Description This universal mount adjustable fishing rod holder will install just about anywhere you can think of. The included mounts and stainless fasteners allow for placement on rails or surfaces, vertical or horizontal. The holder rotates through 360 degrees of movement and can tilt up and down with a thumb bolt lock.

T-H Marine Supplies Universal Rod Holder

Molded of tough, flexible, vinyl. It is designed for multiple uses in boats, such as cable pass thru, landing net holder, fishing rod support or protector, stern light holder or any number of other uses. For bulk head pass-thru, simply mount and run cables, wires, etc. through to prevent chafing. For land nets, fishing rods, stern light or other items, simply mount and insert items to be protected or held in place. To remove items from utility grommet, simply pull.

T-H Marine Utility Grommet

Item # 985297 Features: Injection molded of UV stabilized poly material for strength and durability Length: 11 3/4 Inside Diameter: 1 7/8

T-H Marine Rod Holder - Vertical Side Mount

Rod Holding Devices - T-H Marine Supplies

Tournament Kayak Rod Rack Accessory - Horizontal Track Mounted Rod Holder T Slot

The Flush Mount Rod Holder with Pad Eye Kit from YakGear confidently secure all fishing poles on board with the YakGear Flush Mount Rod Holder Kit. The patent-pending design features an integrated pad eye into the deck side of the flush mount rod holder to leash your fishing pole. With a fully sealed bottom and a bottom mounted gimble, the flush mount rod holder solves the industry-wide problems of interior leaking and movement within the rod holder.

YakGear Flush Mount Rod Holder Kit

Rod Holders –

Side Mount Rod Holders The Rod Holder is injection molded of UV stabilized poly material for strength and durability. Holes are provided for screw mounting either individually or in multiples on a rack. A slot is provided for the reel to slip into to prevent the rod from moving. The Rod Holder is 11 3/4 long with an inside diameter of 1 7/8. The spacing between the two mounting holes is 6 1/4.